Setting up the camera and tripod

Setting up your Tripod:
-Open the Tripod, and push up the centre bit
-Place your Tripod on a level ground
-Extend the first set of legs fully (if you need the camera to be at a higher angle, extend the next set of legs) and lock them back in place

-Slot your camera on the top, using the screws underneath
-Use the handle on the top left of right, to get a panning shot
-Also use the same handle to move the camera up and down, adjusting the twisty screw to allow it to move.

Camera:
-Once the camera has been slot into place on the tripod, turn it on and open the view finder
-Use the handle to adjust where you want the camera
-Use the zoom button to zoom in and out for close up etc..
-Press the record button to start the recording and press it again to stop.